Mitsubishi Electric FR-E700EX Instruction Manual page 182

Misoperation prevention and parameter setting restriction
(5) Restart (PS reset) method when PU stop (PS display) is made during PU operation
 PU stop (PS display) is made when the motor is stopped from the unit where control command source is not selected
(operation panel, parameter unit (FR-PU07) in the PU operation mode.
For example, when Pr.551 PU mode operation command source selection = "9999" (initial value), the motor is stopped from
the PU (PS display) if entered from the operation panel
When the motor is stopped from the PU when the parameter unit (FR-PU07) is selected as control
command source.
1) After the motor has decelerated to a stop, press
2) Press to display
3) Press of the parameter unit (FR-PU07) to select the PU operation mode.
4) Press or of the parameter unit (FR-PU07).
REMARKS
 When Pr.551 = "9999", the priorities of the PU command source is USB connector > parameter unit (FR-PU07) > operation
panel.
Do not reset the drive unit while the start signal is being input.
Otherwise, the motor will start instantly after resetting, leading to potentially hazardous conditions.
Parameters referred to
Pr.250 Stop selection
Pr.551 PU mode operation command source selection
180
. ( reset )
CAUTION
Refer to page 137
Refer to page 195
in PU operation mode with the parameter unit mounted.
of the parameter unit (FR-PU07).