ABB ACH580 Series User Manual page 146

ACH580 E-Clipse bypass and packaged drive user manual
Instance
ID
BV22
Note: For Present Value Access Types, R = Read-only, W = Writeable,
C = Commandable. Commandable values support priority arrays and relinquish
defaults.
BACnet analog value object instance summary – Bypass
The following table summarizes the Analog Value Objects supported:
Instance
ID
AV0
AV1
AV2
AV3
AV4
AV5
AV6
AV7
AV8
AV9
AV10
AV11
AV12
AV13
AV14
Object Name
MBOX WRITE This object writes the data value
specified by AV14, MBOX DATA,
to a parameter (defined by AV13,
MBOX PARAM).
Object Name
CURRENT This Object indicates the measured
output current. The corresponding
bypass parameter is 0101.
BYPASS MODE This Object indicates the Hand/Off/Auto
status of the bypass. 0=OFF; 1=HAND;
2=AUTO.
BYP RUN DLY This Object sets the bypass Run delay.
The corresponding bypass parameter is
1614
LAST FLT This Object indicates the last fault
recorded by the bypass. The
corresponding bypass parameter is 0401
WARNING This Object indicates the first warning
WORD 1 status word of the bypass. The
corresponding bypass parameter is 0308
WARNING This Object indicates the first warning
WORD 2 status word of the bypass. The
corresponding bypass parameter is 0309
INPUT VOLT Average of line-line input voltage
PCB TEMP DEG C of bypass board
KW HOURS Bypass mode kilowatt hours
RUN TIME Bypass mode run hours
A-B VOLT Phase A - Phase B voltage
B-C VOLT Phase B - Phase C voltage
C-B VOLT Phase C - Phase A voltage
MBOX PARAM This object defines the parameter to be
read or written to by the mailbox function.
See BV21 and BV22.
MBOX DATA This object holds the mailbox function's
parameter value - a value that was read,
or is to be written. See BV21 and BV22.
Description
Inactive Text
WRITE /
RESET
Description
137
Active/ Present Value
Access Type
W
Present Value
Units
Access Type
Amps R
None R
Secs W
None R
None R
None R
Volts R
DEG C R
kWh W
Hrs W
Volts R
Volts R
Volts R
None W
None W
Embedded fieldbus