Mitsubishi Electric C80 Series Connection And Set Up Manual page 195

C80 Series Connection and Setup Manual
11 CNC CPU Initial Setup
[When connecting three units of CNC CPU]
(Note) To connect three units of CNC CPU, set "#26751 DevCondenseRef" to "1". If "1" is not set, a setting
error occurs in the subsequent settings.
(a) Device setting of NC1
(Note)
(a-1) Perform the device setting on CPU1 side of NC1.
CPU1 (PLC CPU side): Setting example of three units of CNC CPU, 2-part system and 8 control
axes
(a-2) Perform the device setting on CPU2 side of NC1.
Press [Next CPU] at the bottom right. Confirm that [CPU2] is displayed in the top right.
CPU2 (CNC CPU side): Setting example of three units of CNC CPU, 2-part system and 8 control
axes
IB-1501452-C
When the [Execute init.] menu is pressed at NC1, the settings for (a-1) to (a-4) are performed
automatically.
164