Start-Up And Control With I/O; What This Chapter Contains; How To Start Up The Drive - ABB ACS150 series User Manual

Start-up and control with I/O

What this chapter contains

The chapter instructs how to:
• perform the start-up
• start, stop, change the direction of the motor rotation and adjust the speed of the
motor through the I/O interface.
Using the control panel to do these tasks is explained briefly in this chapter. For
details on how to use the control panel, please refer to chapter
page 57.

How to start up the drive

The safety instructions given in chapter
the start-up procedure.
The drive starts up automatically at power-up if the external run command is on and
the drive is in the remote control mode.
Check that the starting of the motor does not cause any danger. De-couple the
driven machine if there is a risk of damage in case of incorrect direction of rotation.
Check the installation. See the checklist in chapter
Before you start, ensure that you have the motor nameplate data on hand.
Apply input power.
The panel powers up into the Output mode.
Select the application macro (parameter
MACRO) according to how the control cables are connected.
The default value 1 (ABB STANDARD) is suitable in most cases.
The general parameter setting procedure in the Short parameter mode is
described below. You can find more detailed instructions on setting
parameters on page 65.
WARNING! The start-up may only be carried out by a qualified
electrician.
POWER-UP
ENTRY OF START-UP DATA
9902 APPLIC
Safety on page 11 must be followed during
Installation checklist
LOC
OUTPUT
LOC
Start-up and control with I/O
51
Control panel on
on page 49.
0 0
.
Hz
FWD
9902
s
PAR FWD