Installation Checklist; Checking The Installation - ABB ACS150 series User Manual

Installation checklist

Checking the installation

Check the mechanical and electrical installation of the drive before start-up. Go
through the checklist below together with another person. Read chapter
page
Check
MECHANICAL INSTALLATION
The ambient operating conditions are within allowed limits. (See
Checking the installation site
noise on page
The drive is fixed properly on an even vertical non-flammable wall. (See
installation on page 23.)
The cooling air flows freely. (See
page 23.)
The motor and the driven equipment are ready for start. (See
installation: Checking the compatibility of the motor and drive
data: Motor connection data
ELECTRICAL INSTALLATION (See
installation on page 39.)
For ungrounded and corner-grounded systems: The internal EMC filter is disconnected
(screw EMC removed).
The capacitors are reformed if the drive has been stored over a year.
The drive is grounded properly.
The input power voltage matches the drive nominal input voltage.
The input power connections at U1, V1 and W1 are OK and tightened with the correct torque.
Appropriate input power fuses and disconnector are installed.
The motor connections at U2, V2 and W2 are OK and tightened with the correct torque.
The motor cable, input power cable and control cables are routed separately.
The external control (I/O) connections are OK.
The input power voltage cannot be applied to the output of the drive (with a bypass
connection).
Terminal cover and, for NEMA 1, hood and connection box, are in place.
11 of this manual before you work on the drive.
on page
142 and Ambient conditions
Mechanical
on page 144.)
Planning the electrical installation
23 as well as Technical
on page 147.)
installation: Free space around the drive
Safety
Mechanical installation:
data: Losses, cooling data and
Mechanical
Planning the electrical
on page 30 as well as
on page 29 and Electrical
Installation checklist
49
on
on
Technical