Setting Snmp Parameters - Huawei TE40 Administrator's Manual

HUAWEI TE40&TE50&TE60 Videoconferencing
Endpoint
Administrator Guide
Parameter
Preferred IP
protocol
Face detection
Site called
during startup
Call times

13.4 Setting SNMP Parameters

To enable the videoconferencing network management system to manage your endpoint,
configure the Simple Network Management Protocol (SNMP) settings.
Your endpoint communicates with and is remotely managed by the videoconferencing
network management system using SNMP. The videoconferencing network management
system implements the following:

Issue 01 (2013-09-30)
Description
when you rejoin the conference.
NOTE
To view the Presentation bandwidth
[frame rate] value, choose Advanced >
Diagnostics > Status > Conference.
Specifies the protocol that IP sites
preferentially use.
When Line type is set to Auto for IP
sites, your endpoint uses this protocol to
call the IP sites.
Specifies whether to perform HD
encoding and decoding to improve face
recognition video quality.
You can increase the video sharpness by
enabling this parameter in low
bandwidths.
Specifies the site that your endpoint
automatically calls when it starts.
 None: The endpoint does not call any
sites.
 Select site from address book: The
endpoint displays the address book
screen from which you can specify
the site you want your endpoint to
call after its startup.
You can proceed to set Call times only
after you set this parameter.
Specifies the maximum number of
attempts your endpoint calls a specified
site after startup.
Configures endpoint settings, including the H.323, SIP.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
13 Feature Configuration
Setting
The default value is H.323.
The default value is Disable.
The default value is None.
The default value is 1.
The maximum value is 10.
If you set this parameter to
0, your endpoint does not
call the specified site after
startup.
147