Huawei TE40 Administrator's Manual page 98

HUAWEI TE40&TE50&TE60 Videoconferencing
Endpoint
Administrator Guide
The following parameters are important site attributes: Name, Number, Rate, Type, and IP
address.
Table 6-6 Site parameters
Paramet
er
Category
Type
Number
IP
address
Rate
URI
Issue 01 (2013-09-30)
Table 6-6 lists these parameters.
Description
Specifies the category of the site.
Specifies the line the site uses to access
the videoconferencing network.
 If you select IP, your endpoint uses
the protocol specified Preferred IP
protocol to call the site.
 If you set Category to CT site, the
available value for this parameter is
SIP.
Specifies the site number used to place
calls between sites.

IP, T1, 4E1, basic rate interface
(BRI), and H.323 phone site
numbers are allocated by the
videoconferencing service provider.
 PSTN site numbers are telephone
numbers.
Specifies the site IP address.
NOTE
This parameter is unavailable if you set
Category to IP address.
Specifies the call rate for the line
selected for a remote endpoint.
The call rates supported vary depending
on the type of the site you want to call.
Specifies the uniform resource identifier
(URI) of the site, for example,
abcd@huawei.com.
NOTE
This parameter is available only when Type
is set to IP, H.323, or SIP.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 Conference
Setting
The default value is Ordinary site.
 Ordinary site: Select this
option for a traditional
videoconferencing site.
 Telepresence site: Select this
option for a Huawei
telepresence site.
 CT site: Select this option for a
Cisco TelePresence site.
The default value is H.323.
No default value is set for this
parameter.
No default value is set for this
parameter.
The default value is 8Mbps.
Select the highest available call
rate.
No default value is set for this
parameter.
90