Adjusting The Speaker Volume; Connecting A Tuning Console; Adjusting Audio Effects - Huawei TE40 Administrator's Manual

HUAWEI TE40&TE50&TE60 Videoconferencing
Endpoint
Administrator Guide


5.2.3 Adjusting the Speaker Volume

Press
volume heard only at the local site.

5.3 Connecting a Tuning Console

If a conference room requires multiple microphones or already has a tuning console for
controlling microphones, you can connect the tuning console to the endpoint as the endpoint's
audio input source.
Connect the output interface of the tuning console to the RCA L/R audio input interface of the
endpoint using an RCA audio cable.

5.4 Adjusting Audio Effects

You can adjust the audio effects, such as the audio input, sound effect, and volume.
Background
For details about how to adjust the audio input, see
section only describes how to adjust the sound effect and the volume.
Procedure
Step 1 Choose Advanced > Settings > Audio and then set the parameters listed in
Table
Table 5-8 Sound effect parameters
Parameter
Ringtone
Locally output
sound from
AUDIO IN
AUDIO IN
remote output
Mix PSTN
audio
Issue 01 (2013-09-30)
If you are using an omnidirectional microphone, the distance between the speaker and
microphone must be more than 1 meter.
to increase the volume or
5-9.
Description
Specifies the ringtone for incoming calls.
Specifies whether to allow the audio input
from the LINE IN port, the HDMI port or the
RCA port to be heard at your site.
Specifies whether to allow the audio input
from the LINE IN port, the HDMI port or the
RCA port to be heard at remote sites.
Specifies whether all the participants
(including PSTN participants such as mobile
phones) in a a multipoint conference can hear
each other.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
to decrease the volume. The adjustment affects the
5.1.3 Setting Audio
5 Microphone and Speaker
Parameters. This
Table 5-8 and
Setting
The default value is
Default.
This parameter is not
selected by default.
This parameter is
selected by default.
This parameter is
selected by default.
Retain the default value
when the endpoint
joins a multipoint
67