Huawei TE40 Administrator's Manual page 25

HUAWEI TE40&TE50&TE60 Videoconferencing
Endpoint
Administrator Guide
Parameter
Scheduled
power-on
Scheduled
power-on time
Scheduled
power-off
Scheduled
power-off time
Step 2 Select Save.
The endpoint enters sleep mode, and the LED indicator blinks purple once every 2 seconds.
----End
Follow-up Procedure
The endpoint wakes up from sleep mode in response to any of the following conditions:

Issue 01 (2013-09-30)
Description
Wake on LAN (WOL) messages.
NOTE
A standby endpoint indicates that
the power switch on the endpoint's
rear panel is in the ON position and
that the endpoint is turned off by
pressing the power key on the
remote control.
Specifies whether the endpoint
automatically powers on at the
specified time.
NOTE
If you enable this function, you
must also set Scheduled power-on
time (hh:mm).
Specifies the time when the
endpoint automatically powers
on.
The value format depends on the
value set for Time format.
Specifies whether the endpoint
automatically powers off at the
specified time.
NOTE
If you enable this function, you
must also set Scheduled power-off
time (hh:mm).
Specifies the time when the
endpoint automatically powers
off.
The value format depends on the
value set for Time format.
To directly place the endpoint in sleep mode, press
You use the touch panel.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 Basic Configuration and Verification
Setting
This parameter is not selected by
default.
The default value is 0:0, which
corresponds to the 24-hour value
for Time format.
This parameter is not selected by
default.
The default value is 0:0, which
corresponds to the 24-hour value
for Time format.
on the remote control and select Sleep.
17