Huawei TE40 Administrator's Manual page 159

HUAWEI TE40&TE50&TE60 Videoconferencing
Endpoint
Administrator Guide
Parameter
IP priority
Service type
DSCP audio
DSCP video
DSCP data
DSCP signaling
Network jitter
Lip sync.
Issue 01 (2013-09-30)
Description
must also set IP priority and Service
type.
 DiffServ: If you select this option, you
must also set DSCP.
Specifies the priority that a network device
gives to forwarding the data packets sent
by your endpoint.
A larger value indicates a higher priority.
Specifies how the data packets sent and
received by your endpoint are processed on
the network.
 Normal: Network devices transmit the
data packets without special processing.

Minimum delay: Data packets are
transmitted at the highest rate with the
minimum delay.
 Maximum throughput: A large
number of data packets can be
transmitted on the network.
 Highest reliability: Data packets can
be transmitted to remote sites
completely and correctly.
 Minimum cost: Network devices
transmit data packets of the same traffic
at lower costs.
Specify the service level of data packets
sent by your endpoint during transmission.
A larger value indicates a higher service
level.
Adjusts network jitter settings to address:
 Labial synchronization problems during
conferences
 Choppy audio problems, by increasing
the network jitter value.
Fine-tunes network jitter settings if a slight
labial synchronization problem persists
after the network jitter settings are
adjusted.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
13 Feature Configuration
Setting
The default value is 7.
Value range: 0-7
The default value is
Minimum delay.
The default value is 63.
Value range: 0-63
The default value is
0ms.
Value range: 0 ms to
1000 ms
The default value is
0ms.
Value range: 0 ms to
300 ms
151