NorthStar MX500 Operator's & Installation Manual page 94

Operator's Manual
If you highlight the Return softkey and press ENT, then highlight
the Track Plotter softkey and press ENT, you will access the recorded
track options.
80
only displayed for the leg of the course you are presently on. If
you reset your cross-track error, these lines are redrawn to reflect
the course change (see NAV2). No causes the cross-track error
lines not to be displayed. Note that these lines can only be dis-
played in Rhumb Line navigation mode (see CFG1 Navigation).
Show Lat/Lon Grid - No is the default condition, which causes the
coordinate grid not to be displayed. Yes causes the Lat/Lon grid to
be displayed (regardless of positioning reference system selection
in CFG1 Position). Note that the grid is only displayed at the 4
Nm scale or lower.
Automatic Zoom - No is the default condition, which causes the
displayed scale to be controlled by you. Yes causes the boat icon to
be placed along one edge of the screen and the next waypoint flag
to be placed along the opposite edge of the screen. As you ap-
proach your waypoint, the screen will automatically zoom in on
your course, then expand back out after you pass the waypoint
and start the next leg of your course.
Plot
Version 3.0