Erasing An Existing Route - NorthStar MX500 Operator's & Installation Manual

Route
Below Waypoint 0 is the waypoint you defined in the GOTO func-
tion. Notice that this information is in standard video, black charac-
ters on a white background, and that an ETA time is displayed in the
same position as the waypoint passed time in Waypoint 0. This indi-
cates that the waypoint has not yet been passed. Remember that the
ETA time is filtered over time, so allow a few minutes for the filter to
settle when you first get underway or make course and speed changes.

Erasing an Existing Route

To erase the active route:
1. Select the RTE key until the RTE1 screen is displayed.
2. Press the EDIT key.
3. Highlight the Remove softkey and press the ENT key.
4. Highlight the Erase Route softkey and press the ENT key.
5. Highlight the Yes softkey and press the ENT key to confirm.
The active route is now erased and ready for new input. If you want
to work in other areas of the CDU first, you will need to press the
EDIT key to exit the edit mode.
Version 3.0
Operator's Manual
37