Insert By Number - NorthStar MX500 Operator's & Installation Manual

Route

Insert By Number

The following example assumes RTE1 is empty. Follow the direc-
tions in the Erasing an Existing Route section to start with an empty
route if you have waypoints in the RTE1 screen.
1. Select the RTE key until the RTE1 screen is displayed.
2. Press the EDIT key to enter the edit mode.
3. Highlight the Insert softkey from the display and press the ENT
4. Highlight Insert by Number softkey from the display and press
5. Use the EDIT keypad to type in the number you want or the be-
6. When you have found the waypoint you want, highlight the In-
7. You can then choose to select another waypoint using the same
8. Don't forget to press the EDIT key to end your editing.
Version 3.0
key. Skip to the next step if RTE1 is empty.
the ENT key.
ginning number of a range you would like to select from, or use
the cursor key to scroll through the previously stored waypoints
in numerical order.
sert this WPT softkey and press ENT.
method, highlight Escape and press ENT to go back one level
and use another method to enter waypoints, or highlight Done
and press ENT to go back to the main menu.
Operator's Manual
39