Rot (Rate Of Turn); Security - NorthStar MX500 Operator's & Installation Manual

Operator's Manual

ROT (Rate of Turn)

The ROT configuration menu is available in the MX500 model. The
"ROT connected" mode can be toggled to YES or NO, by pressing the
EDIT key and then highlighting the 'Change' softkey and press ENT.
Data input port no: ...2 (valid port selections are 1,2, or 3*)
Alarm if no data: ....No ('Yes' value sets the alarm to sound if no ROT
*Use MX575 ROT: ...No ('Yes' value would allow the MX500 to use

Security

The Security screen allows you to lock out the EDIT key in order to
keep crew members or visitors from changing settings that you have
made. Once this feature is enabled, a press of the EDIT key will require
the correct password to gain access. To disable the security functions,
you will be prompted to enter a 5 digit password. You will then be
prompted to reenter the password. The security function is then dis-
abled until you enter a new password through the CFG1 Security
screen again. Be sure to keep your password in a safe place. If you lose
your password, you will need to call the factory to reset the security
feature.
144
input data is detected in 5 seconds)
ROT data from Port 3 when the MX575 is
used as a positiong and heading device.
'No' value would allow the MX500 to use
ROT data from any available port other than
Port 3 when the MX575 is used as a heading
device only (See MX575 Satellite Compass
Installation and Operation Manual for de-
tails).
Configuration
Version 3.0