Operator's Manual
To cancel an MOB condition, make sure you are in the MOB Plot
screen. Press the EDIT key, then highlight the Cancel MOB softkey
and press ENT. Press EDIT again to exit the edit mode.
Remote MOB
The MX500 is capable of performing the MOB function from a re-
mote contact closure input via the AUX (8-pin) cable. If the contact
closure is made for 3 seconds, the input is registered as a MOB Posi-
tion. Refer to the Appendix F of this manual for wiring interface
instructions.
86
Auxiliary
Version 3.0