Memory Backup Battery; Backup Battery Replacement; Mx500 Pc Interface - NorthStar MX500 Operator's & Installation Manual

Table of Contents

Advertisement

Installation Notes

Memory Backup Battery

The internal real time clock and memory which stores the waypoints,
alarm limits, etc., is backed up by a lithium battery. The expected life
time is 2 years at 21° C, but this is based on the temperature the navi-
gator is stored at when not in use. The higher the temperature, the
shorter the life and vice versa.

Backup Battery Replacement

Marine electronics dealers or radio supply stores will typically stock the
replacement battery, Type TL-5902, 3.6 V (1/2 AA) Lithium battery.
The battery is mounted in a socket located on the MX 500 processor
board. BNT-ME recommends this service to be done by a qualified
service technician.
MX 500 PC Interface
The MX 500 data ports 1 & 2 are both RS-422 type data interface. If
you need to connect the MX 500 to a PC we recommend using an RS-
422 to RS-232 converter as shown below.
To PC
Serial Port
Version 3.0
12 VDC
-
+
B&B Electronics
RS-422 to RS-232
Converter
Model 422LP9TB
PC Interface Cable Diagram
PWR/Data Cable
(12-Pin Connector)
Negative GND (Black)
10.5 to 32 VDC (Red)
NMEA TX1 - (Blue)
NMEA TX1 + (Brown)
NMEA RX1 - (Orange)
NMEA RX1 + (Green)
NMEA TX2 - (Yellow)
NMEA TX2 + (White)
NMEA RX2 - (Purple)
NMEA RX2 + (Grey)
GND Fast Channel IN (lite Green)
Shield
Installation Manual
MX 500
227

Advertisement

Table of Contents
loading

Table of Contents