Nav5 - Compass Display Screen - NorthStar MX500 Operator's & Installation Manual

Operator's Manual
Below this information, you will find your Set and Drift data, which
is calculated using GPS and your compass and speed sensor inputs.
Reset XTE and Skip Waypoint, described at the end of NAV2, is also
available in NAV4.
The window on the right displays depth information coming from
the depth sounder unit using the NMEA 0183 record of DPT, DBS,
DBT, or DBK. These are setup in the CFG1 Depth screen, refer to
the Configuration section and the Appendix F of this manual for full
details on depth data.
Below the depth data you will find the next route leg vector, the
Range to the waypoint and Time To Go data, explained in the NAV3
section.

NAV5 - Compass Display Screen

The NAV 5 screen is used to display the Heading and Rate of Turn
values given by a heading sensor like the MX575 Satellite Compass.
In addition, it also displays the position, COG, SOG, BRG, and RNG.
This screen can be accessed by pressing the NAV key repeatedly until
you reach the desired NAV screen.
30
Route
Version 3.0