Message Information - Toshiba TOSVERT VF-AS3 Instruction Manual

■ Message information

Message
display
A-01
A-02
A-05
ASIA
4
Atn
4
CHn
CLr
db
8
dbOn
9
E1
E2
E3
EASy
End
13
EOFF
Err1
EU
FAIL
FIrE
FJOG
13. Trip information and measures
English
V/f 5-point setting When <Pt:V/f Pattern> = "7: V/f 5-point set-
error 1 ting", two or more from <vL>, <F190>,
<F192>, <F194>, <F196> and <F198> are
set to the same value other than 0.0 Hz.
V/f 5-point setting Inclination of V/f is large.
error 2
Base frequency set- Tries to run in frequency over 10 times of the
ting error base frequency.
Setting for Asia Setting for Asia is selected in the setup
menu.
During auto tuning Auto-tuning in progress.
Setting for China Setting for China is selected in the setup
menu.
Reset command The following was operated after trip is
acceptable occurring.
1) Pressed [STOP] key once.
2) Set the reset terminal ON.
(During trip resetting operation)
During DC braking DC braking in progress.
During motor shaft Motor shaft fixing in progress.
fixing
Panel display one The display digit on the operation panel over-
digit overflow flowed by one digit.
Panel display two The display digit on the operation panel over-
digits overflow flowed by two digits.
Panel display three The display digit on the operation panel over-
digits overflow flowed by three digits.
Easy mode Switched to [Easy mode].
Last of data The last data item in <History function>.
Emergency off com- When a run command is other than the
mand acceptable operation panel, [STOP/RESET] key was
pressed once.
Frequency point The setting on point 1 and point 2 of the fre-
setting error quency command is close.
Setting for Europe Setting for Europe is selected in the setup
menu.
Password failure Entered number in <F739: Password verifi-
cation> does not match <F738: Password
setting>.
During Fire speed Fire speed run/Forced run is in progress.
run/Forced run ("FIrE" and the output frequency are alter-
nately displayed)
Fwd JOG Forward jog run in progress.
Description
Set different value on each parameter.
Set V/f 5-point and <vLv>/<vL> for the V/f
inclination to be gentle.
• Check that the base frequency setting is
• Operate in frequency within 10 times of the
-
A message that indicates auto-tuning in
progress. No problem if the message disap-
pears after several seconds.
-
Reset is performed with the following opera-
tion.
1) Press [STOP] key again.
2) Set the reset terminal OFF.
-
A message indicates the motor fixing control
in progress. When standby is turned OFF, the
control stops.
-
-
-
-
-
To apply emergency off, press [STOP] key
again.
If emergency off does not occur, press other
keys.
Set apart point 1 and point 2 of the frequency
command.
-
-
A message indicates fire speed run/forced
run in progress. It stops when turning the
power OFF.
-
13-10
E6582062
Remarks
correct. <vL: Base frequency 1>, etc.
base frequency.