Compliance With Low Voltage Directive; Low Voltage Directive Compliance Of This Inverter; Example Of Measures To Comply With Low Voltage Directive; Measures For Operation With External Signals - Toshiba TOSVERT VF-AS3 Instruction Manual

Part
Shielded wire
Zero-phase reactor
(3)

Measures for operation with external signals

To operate with external signals, take measures as shown in the figure below (e.g.: using a
potentiometer and Fwd/Rev terminals).
PP
RR
CC
F
R
CC
Part
Shielded wire
9. 1. 2

Compliance with Low Voltage Directive

The Low Voltage Directive provides for the safety of machines and systems.
(1)

Low Voltage Directive Compliance of this inverter

Inverters are CE-marked in accordance with the standard IEC61800-5-1 specified by the Low
Voltage Directive, and can therefore be installed in machines or systems and exported
without problem to European countries.
• Applicable standard: IEC61800-5-1
• Pollution level: 2
• Overvoltage category: 3
(2)

Example of measures to comply with Low Voltage Directive

When incorporating the inverter into a machine and system, it is necessary to take the
following measures so that the inverter satisfies the Low Voltage Directive.
Installing in cabinet
• Install the inverter in a cabinet and ground the inverter enclosure.
• When doing maintenance, be extremely careful not to put your fingers into the inverter
through a wiring hole and touch a charged part, which may occur depending on the model
of the inverter used.
• Rating: 600 V or less
• Cross-section area: 2 - 1000 mm
If a shielded wire is difficult to obtain, shield with a conduit.
Option:
RC5078ZZ
RC9129ZZT
Ferrite core
Shielded wires
• Rating: 600 V or less
• Cross-section area:
2
2 - 1000 mm
9-5
Specifications/remarks
2
Specifications/remarks
9. Measures to satisfy standards
E6582062
Under application
3
9