NEC Univerge SV9100 Manual page 762

Hide thumbs Also See for Univerge SV9100:

Table of Contents

Explanation of routing for IP AspireNet .

When a user places a call to a remote extension number the dialed digits are checked against the Number-

ing Scheme in Program 11-01. This will provide the Node ID number of the route to the remote system.

The SV9100 will then find the destination IP Address by searching Program 10-27 for the destination IP

Address for the given Node ID number.

Quantity of Voice Paths Available.

The quantity of voice calls that can be made at any one time are dependent on various factors.

IPLA Resource - A free IPLA resource must be available at each SV9100 system.

Program 10-19 - The mode of each VOIPDB resource can be configured, modes 0 (ICM/Trunk) or 3 (NTW)

can be used by AspireNet calls.

IP Network Bandwidth Restrictions - These limitations are beyond the scope of the SV9100 . If there is not

enough bandwidth available the call can not be maintained.

SV9100 Networking Manual