Section 4 Example Configurations - NEC Univerge SV9100 Manual

Hide thumbs Also See for Univerge SV9100:

Table of Contents

Assume that a UNIVERGE SV9100 is added to the existing data network. The

Network Administrator (or IT Manager) should provide the following:

IP Address (for the GCD-CP10 blade)

IP Addresses (for the GPZ-IPLE daughter board)

Default Gateway

A spare switch/hub port

First, program the UNIVERGE SV9100:

192.168.1.200

255.255.255.0

PRG10-12-03: 192.168.1.254

A system reset is required for the IP Address changes to take effect.

Now connect the GCD-CP10 blade Ethernet Port to the switch/hub port, using a

standard Cat-5 patch cable. The UNIVERGE SV9100 is now configured on the

network and should be accessible by other devices on the network. Refer to

Figure 3-2 Example Configuration 1 - Adding the UNIVERGE SV9100 Chassis to

General IP Configuration