NEC Univerge SV9100 Manual page 448

Issue 2.0
Program
Program Name
Number
DT800/DT700
Multiline Basic
84-23-03 Information Setup –
Session Expire
Timer
DT800/DT700
Multiline Basic
84-23-04 Information Setup –
Minimum Session
Expire Timer
DT800/DT700
Multiline Basic
84-23-05
Information Setup –
Invite Expire Timer
DT800/DT700
Multiline Basic
84-23-06 Information Setup –
Signal Type of
Service
DT800/DT700
Multiline Basic
84-23-07
Information Setup –
Error Display Timer
DT800/DT700
Multiline Basic
Information Setup –
84-23-08
Digest Authorization
Registration Expire
Timer
DT800/DT700
Multiline Basic
84-23-10 Information Setup –
Number of
Password Retries
SV9100 Networking Manual
Description/Comments
At half the value of this timer the IP
terminal sends a re-invite message.
Minimum time the CPU accepts a
session timer for a new call.
When INVITE message received
from SIP MLT does not contain
Expires header, the CPU uses this
value for timeout of outgoing call.
E.g. The SIP MLT hears RBT for
duration of this timer and then is
disconnected.
Used for updating the IP terminals
SIGNALING TOS values.
The time that an IP terminal holds
an error message in the display.
Setting 0 holds the error message
indefinitely.
When Digest Authentication mode is
ON, this value is available.
After receiving Initial INVITE without
authentication information, CPU will
send 401 message to the SIP MLT,
then waits for an INVITE message
with the authentication message
from SIP MLT within this timer.
Additionally, after receiving Re-
REGISTER message for Keep Alive
purpose, the CPU sends a 401
message.
The number of times an incorrect
password can be entered when the
security key is pressed.
If set to (1), only one attempt is
allowed. When number of password
retries is met an error message
displays on the phone: Incorrect
security code password entered,
press call key to contact an
administrator
Assigned Data
Range: 60~65535 Sec.
Default is 180
Range: 60~65535 Sec.
Default is 180
Range: 0~65535 Sec.
Default is 180
Range: 0x00 ~ 0xFF
Default is 00
Range: 0 ~ 65535 Sec.
Default is 0
Range: 0 ~ 4294967295
Default is 0
Range: 0 ~ 255
Default is 0
1 2 3
X
X
X
X
X
X
X
8-57