NEC Univerge SV9100 Manual page 367

Issue 2.0
SIP Trunk E.164 Support
Program
Program Name/Description
Number
10-02-01 Location Setup – Country Code
Enter the country code.
10-02-02 Location Setup – International Access
Codes
Enter the international access code.
44-01-02 System Options for ARS/F-Route – Dial
Tone Simulation
When first dialed, digit matches the data set in
this Program, system sends simulated DT to
calling party after receiving first digit.
Numbering plan for the dial needs to be
configured as F-Route in Program 11-01.
44-01-03 System Options for ARS/F-Route – Tone
Type
Set simulated DT to type which can change the
tone used in Program 44-01-02 and Program
44-02-04.
84-14-13 SIP Trunk Basic Information Setup –
Incoming/ Outgoing SIP Trunk for E.164
When this data is set to 1, then for any
outbound SIP calls a + is added as a prefix to
the Request-URI, To and From header fields of
the SIP message.
When it is set to 2 then if the dialed international
access code matches the value in Program
10-02-02 this value is removed from the
number dialed and the + added as a prefix to
the Request-URI, To and From header fields of
the SIP Message.
SIP Trunk E.164 CLIP Enhancement
Program
Program Name/Description
Number
10-02-01 Location Setup – Country Code
Enter the country code.
10-02-02 Location Setup – International Access
Codes
Enter the international access code.
10-02-03 Location Setup – Other Area Access Code
Enter the other area access code.
SV9100 Networking Manual
Input Data
Dial (maximum of four digits)

0 ~ 9, , #
Dial (maximum of four digits)

0 ~ 9, , #
Dial (maximum of one digit)

0 ~ 9, , # cannot be used
0 = Internal Dial Tone
1 = External Dial Tone
0 = Off
1 = Mode 1
2 = Mode 2
3 = Mode 3
(Profile 1 ~ Profile 2)
Input Data
Dial (maximum of four digits)

, #
0 ~ 9,
Dial (maximum of four digits)

0 ~ 9, , #
Dial (maximum of two digits)

0 ~ 9, , #
Level
Default
1 2 3
1

No Setting

No Setting

0

0

Level
Default
1 2 3
1

No Setting

9

6-21