NEC Univerge SV9100 Manual page 361

Issue 2.0
Program
Program Name/Description
Number
22-02-01 Incoming Call Trunk Setup
Assign the incoming trunk type for each trunk.
44-02-01 Dial Analysis Table for ARS/F-Route Access
– Dial
Set the Dial digits for the Pre-Transaction Table
for selecting ARS/F-Route (eight digits max:
1 ~ 9, 0  # , @). To enter a wild card/don't care
digit, press Line Key 1 to enter an @.
44-02-02 Dial Analysis Table for ARS/F-Route Access
– Service Type
Set the Service Type (0 ~ 3) for the Pre-
Transaction Table for selecting ARS/F-Route.
44-02-03 Dial Analysis Table for ARS/F-Route Access
– Additional Data
If a Service Type is selected in Program
44-02-02, set the additional data, if required, for
the Pre-Transaction Table for selecting ARS/F-
Route (24 digits max: 1 ~ 9, 0  # , @). To enter
a wild card/don't care digit, press Line Key 1 to
enter an @.
44-05-01 ARS/F-Route Table – Trunk Group Number
Assign the trunk group to be used by the ARS/
F-Route Table.
44-05-09 ARS/F-Route Table – Maximum Digit
Input the maximum number of digits to send
when using the F-Route.
84-10-01 ToS Setup – ToS Mode
When Input Data is set to 1, Protocol 7 is
invalid. When Data is set to 2, Protocols 2 ~ 6
are invalid.
SV9100 Networking Manual
Input Data
Trunks 1 ~ 400
0 = Normal
1 = VRS (second
dial tone if no
VRS installed)
2 = DISA
3 = DID
4 = DIL
5 = E&M Tie line
6 = Delayed VRS
7 = ANI/DNIS
8 = DID(DDI) Mode
Switching
Maximum of eight digits.
(Use line key 1 for a 'Don't Care'
digit, @)
0 = No Setting (None)
1 = Extension Call (Own)
2 = ARS/F-Route Table
(F-Route)
3 = Dial Extension Analyze
Table (Option)
1 = Delete Digit = 0 ~ 255
(255: Delete All Digits)
2 = 0 ~ 500
(0 = No Setting)
3 = Dial Extension Analyze
Table Number = 0 ~ 4
(0 = No Setting)
0-100,101-150,255
0 = Not Set
1~100 = Trunk Group from
PRG14-05
101~150 = Networking
255 = Extension Call
Default is 0
0 ~ 24
0 = Disable (Invalid)
1 = IP Precedence
2 = Diffserv
Level
Default
1 2 3
0

No Setting

0

0

0

0

0

6-15