Order Of Installing Trunk Blades; Installing Coiu-Ls1/Lg1, Gcd-4Odta, Gcd-4Diopa, Or Gcd-2Bria Blades; Chapter 2 Hardware Installation <Us Only; Table 2-3 Trunk Blade Installation Order Example - NEC Univerge SV9100 Manual

3
2.3
2-4
Table 2-2 Adding Daughter Board to Chassis Example
GCD-16DLCA 125~140
The system automatically recognizes each Blade installed in the system. If a
Blade was previously installed in a slot and another type of Blade is to be installed
in that same slot, the Blade must be removed from the chassis and then the slot
definition removed using Program 90-05 prior to installing the new Blade.
This same condition applies to extensions and other devices connected to the
system. For example, if a port was previously used for a telephone and a DSS
Console is to be installed in that same port, the telephone must first be undefined
in Program 10-03 before the console is connected.

Order of Installing Trunk Blades

2.3.1 Installing COIU-LS1/LG1, GCD-4ODTA, GCD-4DIOPA, or
GCD-2BRIA Blades
The order in which trunk blades are physically inserted determines the
numbering plan.
CAUTION
For example, if four blades are installed in the following order, the numbering
plan below would apply.

Table 2-3 Trunk Blade Installation Order Example

Installation
1
2
3
4
3
4
:
To avoid unexpected extension/trunk numbering if the VoIP or
Voice Mail blades register with the system first, install
GCD-CP10 blade after the other types of extension and trunk
blades are installed.
Order of Blade Slot
Number
4
5
7
6
GCD-16DLCA 125~140
GCD-8DLCA 141~156
(with daughter
board)
Blade Line Circuits
4COIU 1~4
4COIU 5~8
4TLIU 9~12
4TLIU 13~16
Hardware Installation <US Only>
Issue 2.0