NEC Univerge SV9100 Manual page 722

Issue 2.0
Level:
SA
Description
Use Program 22-11 : DID Translation Table Number Conversion to specify for each Translation Table
entry (2000).
The digits received by the system (eight maximum)

The extension the system dials after translation (24 digits maximum)

The name that should show on the dialed extension display when it rings (12 characters maximum)

The Transfer Target – 1 and 2


If the Transfer Targets are busy or receive no answer, those calls are transferred to the final transfer
destination (Program 22-10).
Operation Mode

Use the following chart when entering and editing text for names. Press the key once for the first
character, twice for the second character, etc. For example, to enter a C, press 2 three times.
When entering names in the procedures below, refer to this chart. Names can have up to 12 digits.
Use this keypad digit . . .
SV9100 Networking Manual
Program 22 : Incoming Call Setup
22-11 : DID Translation Number Conversion
Key for Entering Names
When you want to. . .
1 Enter characters:
1 @ [ ¥ ] ^ _ ` { | }
2 Enter characters: A-C, a-c, 2.
3 Enter characters: D-F, d-f, 3.
4 Enter characters: G-I, g-i, 4.
5 Enter characters: J-L, j-l, 5.
6 Enter characters: M-O, m-o, 6.
7 Enter characters: P-S, p-s, 7.
8 Enter characters: T-V, t-v, 8.
9 Enter characters: W-Z, w-z, 9.
0 Enter characters:
0 ! "
 
# $ % & ' ( ) ô Õ ú ä ö ü
Á À Â Ã Ç É Ê ì ó

13-127