Table 13-3 Keys For Entering Names; Section 21 Programming Names And Text Messages - NEC Univerge SV9100 Manual

Issue 2.0
Table 13-2 Keys for Entering Data (Continued)
Use this key...
4.6 Programming Names and Text Messages
Several programs (e.g., Program 20-16 : Selectable Display Messages) require you to enter text.
Use the following chart when entering and editing text. When using the keypad digits, press the
key once for the first character, twice for the second character, etc. For example, to enter a C,
press the key 2 three times. Press the key six times to display the lower case letter. The name
can be up to 12 digits long.

Table 13-3 Keys for Entering Names

Use this keypad digit . .
.
SV9100 Networking Manual
When you want to...
MIC Switch between the different input data fields by pressing
cursor moves up to the top row of the display. Pressing
moves the cursor back to the middle row.
Use pre-programmed settings to help with the program entry. These
LINE KEYS
settings vary between programs from LINE 1 = 0 (off) and LINE 2 = 1
(on) to preset values for timers where LINE 1 = 5, LINE 2 = 10, LINE 3 =
15, etc.
For programs with this option, the line key, which currently matches the
programmed setting, lights steady.
The display can also indicate Softkey, which will allow you to select the
values as well (-1 and +1 will step through these pre-programmed
settings.)
Program a pause into a Speed Dialing bin.
LINE KEY 1
Program a recall/flash into a Speed Dialing bin.
LINE KEY 2
Program an @ into a Speed Dialing bin.
LINE KEY 3

Scroll backward through a list of entry numbers (e.g., from extension
VOL
etc.) or through entries in a table (e.g., Common Permit Table).
If you enter data and then press this key, the system accepts the data
before scrolling forward.

VOL Scroll forward through a list of entry numbers (e.g., from extension
etc.) or through entries in a table (e.g., Common Permit Table).
If you enter data and then press this key, the system accepts the data
before scrolling backward.
When you want to. . .
1 Enter characters:
1 @ [ ¥ ] ^ _ ` { | }
Enter characters: A-C, a-c, 2.
2
Keys for Entering Data
Æ
. The
MIC
again
MIC
¨
Á À Â Ã Ç É Ê ì ó
13-57