NEC Univerge SV9100 Manual page 463

8-72
❍ The station does not require an Ethernet connection to
enter program mode. Only power is required. Power
can be provided by an AC adapter plugged into the
phone or by POE provided by a data switch. If the data
NOTE
switch is providing POE it MUST be using the 802.3af
standard.
For Basic bench testing only the following assignments
are required:
1
2
3
Network Settings
DHCP Mode - DHCP Disable. Click OK.

IP Address - Enter the IP Address for the station, and click OK.

Default Gateway - Enter the Default Gateway Address, and click

OK. If you are testing without a router/gateway, this must be left at
the default 0.0.0.0
Subnet Mask - Enter the Subnet Mask for the station, and click OK.

SIP Settings
Do not enter any information in the SIP user field. When the phone

boots up, it requires a user name and password. These are
preassigned in the system. When entered correctly, the phone is
provided an extension number.
Server Address & URI - 1

Enter the IP address assigned in command 10-12-09, and click
OK.
SIP Server Port - 1

Enter port 5080, and click OK.
Press the EXIT key until you are back at the Main menu.

Press the SAVE key, and the phone saves the configuration to

memory, reboots itself and registers with the CPU.
Press 0 on the dial pad for configuration mode.
You are prompted with a User Name and Password.
The defaults are:
User Name: ADMIN
Password: 6633222
The user name should already be entered in the
terminal.
Press Set soft key to step down to the password field.
After you enter the password, press the OK soft key.
st
Server Address
st
Server Port
Issue 2.0
IP Multiline Station (SIP)