NEC univerge sv8100 Installation Manual page 190

Issue 4.0
Input Data (Continued)
Item
Item
No.
Time and Date Display Mode
Set how the Time and Date appear on
display telephones. There are eight
display modes.
07
08 LCD Display Holding Time
Disconnect Supervision
Use this option to enable or disable
09
disconnect supervision for the system
trunks.
Time Before Shifting to
Power-Saving Mode
10
Handsfree Microphone Control
Use this option to control the setting
for Multiline Terminal Handsfree
microphone after being disconnected
and reconnected. If set to 0, the
11
microphone is always off when the
terminal is reconnected. If set to 1,
the microphone remains in the same
state it was in when the terminal is
reconnected.
Forced Intercom Ring (ICM Call
Type)
Use this option to enable or disable
12 Forced Intercom Ringing. If enabled,
incoming Intercom calls normally ring.
If disabled, Intercom calls
voice-announce.
13 --- Not Used ---
Caller ID Display Mode
15
18 Dialing Record Display Time
4 - 44
Input Data
1~8
Type 1 = (12 hour) 10 MAR TUE 3:15PM
Type 2 = (12 hour) 3:15PM MAR 10 TUE
Type 3 = (12 hour) 3-10 TUE 3:15 PM
Type 4 = (12 hour) 3:15PM TUE 10 MAR
Type 5 = (24 hour) 10 MAR TUE 15:15
Type 6 = (24 hour) 15:15 MAR 10 TUE
Type 7 = (24 hour) 3-10 TUE 15:15
Type 8 = (24 hour) 15:15 TUE 10 MAR
0~64800 seconds
0 = Disable (Off)
1 = Enable (On)
0 = No shift
1 = 1 minutes
2 = 2 minutes
3 = 4 minutes
4 = 8 minutes
5 = 16 minutes
6 = 32 minutes
7 = 64 minutes
0 = Off
1 = On
0 = Disable (Voice)
1 = Enable (Signal)
0 = Name and Number (Both)
1 = Name
2 = Number
0~64800 seconds
UNIVERGE SV8100
Related
Default
Programming
3
5
1
0 15-02-18
1
0
0
30