NEC univerge sv8100 Installation Manual page 181

UNIVERGE SV8100
15-08 : Incoming Virtual Extension Ring Tone Setup
Description
Use Program 15-08 : Incoming Virtual Extension Ring Tone Setup to assign a
ring tone range (0~4) to incoming virtual extensions assigned to a Virtual Extension
key (Program 15-07). If you enable ringing for the key in Program 15-09, the key
rings with the tone you set in this program. Also see Program 22-03. The chart below
shows the available tones. There are 256 available extension ports.
Input Data
Item
No.
01
ACD Installation Manual
Extension Number
Incoming Ring Pattern
0 = Tone Pattern 1
1 = Tone Pattern 2
2 = Tone Pattern 3
3 = Tone Pattern 4
4 = Incoming Ring
Tone Extension
5 = Tone Pattern 5
6 = Tone Pattern 6
7 = Tone Pattern 7
8 = Tone Pattern 8
Program 15 : 08 – Incoming Signal Frequency Patterns
Incoming Signal
Frequency
Pattern
Pattern 1
Pattern 2
Pattern 3
Default
0: Tone Pattern 1
Type Frequency 1
High 1100
Middle 660
Low 520
High 1100
Middle 660
Low 520
High 2000
Middle 1400
Low 1100
Maximum eight digits
Description
When an extension or a virtual
extension is assigned to the function
key on the key telephone, select the
ring tone when receiving a call on that
key.
For ACD CAR keys, only tone pattern
1 (entry 0) can be used. The
remaining patterns are not checked
with this feature.
Frequency 2 Modulation
1400
760
660
1400
760
660
760
660
540
Issue 4.0
16Hz
16Hz
16Hz
8Hz
8Hz
8Hz
16Hz
16Hz
16Hz
4 - 35