Inspect Constant Velocity Boot; Emergency Box Raising - Toro 07360 Operator's Manual

• Check to make sure the tires turn an equal amount to
the right and to the left. If the tires do not turn
equally, refer to the Workman Service Manual for
the adjustment procedure
1
Figure 72
1. Turn buckle

Inspect Constant Velocity Boot

Front Wheel Drive Only
After every 200 operating hours, inspect constant velocity
boot for cracks, holes or a loose clamp.

Emergency Box Raising

(without starting the engine)
The box can be raised in an emergency by cranking starter
or by jumping hydraulic system.
Starter Method
• Crank starter while holding lift lever in the raise
position. Run starter for 15 seconds then wait 60
seconds before engaging starter again.
• If engine will not crank, the load and box (attachment)
must be removed to service engine or transaxle.
Jumping Hydraulic System
Caution
Before servicing or making adjustments to the
machine, stop engine, set parking brake and
remove key from the switch. Any load material
must be removed from bed or other attachment
before working under raised bed. Never work
under a raised bed without positioning safety
support on a fully installed cylinder rod.
Note: Two hydraulic hoses, each with a male and female
quick coupler, that fit the vehicle couplers are required to
perform this operation.
• Back another vehicle up to the rear of the disabled
vehicle.
Important
The vehicles hydraulic system uses Dexron
IIl ATF. To avoid system contamination, make sure vehicle
used to jump hydraulic system uses an equivalent fluid.
• On both vehicles, disconnect the two quick coupler
hoses from the hoses secured to the coupler bracket
(Fig. 73).
1
1. Quick coupler hoses
• On the disabled vehicle, connect the two jumper hoses
to the hoses that were disconnected (Fig. 74). Cap
unused fittings.
1
2
1. Disconnected hoses
50
Figure 73
1
Figure 74
2. Jumper hoses