Adjusting Accelerator Pedal; Changing Transaxle / Hydraulic Fluid - Toro 07360 Operator's Manual

2. To adjust belt tension:
• Loosen idler pulley mounting nut, move pulley to
increase tension and tighten nut.
Figure 52
1. Fan belt

Adjusting Accelerator Pedal

1. Position vehicle on level surface, stop engine and
engage the parking brake.
2. Adjust ball joint on accelerator cable (Fig. 53) to allow
.200"–.350" of clearance between accelerator pedal arm
and top of diamond tread floor plate, when a 20 lb.
force is applied to center of pedal. Tighten locknut.
Note: Engine must not be running and return spring must
be attached.
Warning
The governor is preset at the factory to a
maximum engine speed of 3650 rpm. If the speed is
not correct, refer to the Workman Service Manual
or contact your authorized Toro
Dealer/Distributor for assistance.
1
2
2. Idler pulley
1
1. Accelerator cable
.200–.350" clearance
Changing Transaxle / Hydraulic
Fluid
Change Transaxle hydraulic fluid, filter and clean strainer
every 800 hours.
1. Position the vehicle on a level surface, stop engine,
engage the parking brake and remove key from ignition
switch.
2. Remove drain plug from side of reservoir and let
hydraulic fluid flow into drain pan. Reinstall and
tighten plug when hydraulic fluid stops draining.
Note: Clean the hydraulic strainer. Refer to Cleaning
Hydraulic Strainer.
44
2
Figure 53
2. Ball joint
Figure 54