Reset Scanner; Scanning While In Base Cradle; Paging; Paging Mode - Honeywell Voyager 1200g User Manual

Reset Scanner

Scanning this bar code reboots the scanner and causes it to relink with the
base.

Scanning While in Base Cradle

If you want to be able to scan bar codes while the scanner is in the base, scan
the following Scanning in Cradle On bar code. If you want to only allow scan-
ning when the scanner is out of the base, scan Scanning in Cradle Off.
Default = Scanning in Cradle On .
Scanning in Cradle Off
Note: When Scanning in Cradle Off is selected, the scanner will not scan any
bar codes while it is in the base. It will only scan when removed from the
base.

Paging

Paging Mode

By default, the paging button on the base pages the scanner associated
with that base. If you want the paging button on your base to be disabled,
scan the following Paging Mode Off bar code. When Paging Mode is off,
the base will no longer page the scanner when the button is pressed. The
3 - 8
Reset Scanner
* Scanning in Cradle On