Draytek Vigor2960 series User Manual page 51

Apply
Cancel
If you choose PPPoE as IPv4 protocol type, click the PPPoE Tab to open the
following page:
Available parameters are listed as follows:
Item
Username
Password
MTU/MRU
Debug
Always On
Fixed IP
Connection
Detection Mode
Vigor2960 Series User's Guide
Click it to save the configuration and exit the dialog.
Click it to exit the dialog without saving the configuration.
Description
Type the user name offered by your ISP.
Type the password offered by your ISP.
Type the value of MTU/MRU. The default value is 1492.
Click Enable to display the PPPoE debug message in
Syslog. The default setting is Disable.
Enable – Click it to enable the function of Always On. The
router will keep network connection all the time.
Disable – Click it to disable the function of Always On.
Enable – Click it to enable the function of Always On. The
router will keep network connection all the time.
Disable – Click it to disable the function of Always On.
Fixed IP Address – Type an IP address here if you choose
Enable for Fixed IP.
Select a detecting mode for this WAN interface. There are
two ways PING and HTTP supported in Vigor router for
you to choose to send the request out.
43