Draytek Vigor2960 series User Manual page 202

Available parameters are listed as follows:
Item
Profile
Enable This Profile
Type
Basic
Apply
Cancel
Description
Type the name of the profile.
Check this box to enable this profile.
There are three types offered here for you to choose. Please
choose IPSec for this case.
Always On – Click Enable to make router always keeping
connection.
Auth Type - The authentication to be used by Pre-Shared
Key or RSA Signature. Choose PSK or RSA for such
profile.
Preshared Key - Type a pre-shared key for authentication if
PSK is selected as Auth Type.
Security Protocol – Choose ESP to specify the IPSec
protocol for the Encapsulating Security Payload protocol.
The data will be encrypted and authenticated. Choose AH to
specify the IPSec protocol for the Authentication Header
protocol. The data will be authenticated but not be
encrypted.
WAN Profile- Choose a wan profile to be used by such
profile.
Local IP/Subnet Mask - Type the IP address and subnet
mask of local host.
Local Next Hop - Specify the gateway for WAN interface.
Usually, use the default setting (leave it in blank).
Remote Host - Type the WAN IP address for the remote
host.
Remote IP / Subnet Mask - Type the LAN IP address and
LAN subnet mask for the remote host.
More Remote Subnet – Add more remote subnet in this
field if required.
Click it to save the configuration.
Click it to exit the page without saving the configuration.
194 Vigor2960 Series User's Guide