Set Up Upconverter Basic Parameters - Cisco GoQAM Installation And Operation Manual

Chapter 4 Provision the IF GoQAM

Set Up UpConverter Basic Parameters

The UpConverter Name is the name assigned to the upconverter.
Ports
The following table lists the Set Up UpConverter Ports field descriptions.
Field
Reserved TSID Range
Input UpConverter Stream
ID
RF Output Ports
The following table lists the Set Up UpConverter RF Output Ports field descriptions.
Field
Modulation
Transport Stream ID
Channel Center Frequency
(MHz)
Continuous Wave Mode
Mute RF Output
Function Keys
The following table describes the function keys on the Set Up UpConverter window.
Field
Add
Open
Delete
Save
Apply
68
Description
Displays the available range of transport stream
IDs
50 – 45000 for Overlay systems

11 – 50999 for Regional Control System (RCS)

Displays the transport stream ID of the currently
selected upconverter
Description
Displays the frequency modulation for the RF
Output ports
Note: The default is 64-QAM for ITU J.83
Annex B.
Displays the identifier of the transport stream
ID for each RF Output ports
Displays the frequency assigned to the
upconverter
This option is not operational at this time.
This option is not operational at this time.
Description
Allows you to add a new RF Output port
Allows you to edit an RF Output port
Allows you to delete an RF Output port
Saves changes and closes the window
Makes changes without closing the window
4004834 Rev D