Cisco GoQAM Installation And Operation Manual page 72

Chapter 4 Provision the IF GoQAM
Basic Parameters
The following table lists the Basic Parameters field descriptions.
Field
Headend Name
QAM Name
IP Address
Modulation Type
Administrative State Specifies whether the GoQAM is active within the
MAC Address
Subnet Mask
Default Gateway
Ports
The following table lists the Ports field descriptions.
Field
Reserved TSID Range
Input Block 1 ASI 1
Clear Transport Stream
ID
Input Block 2 ASI 3
Clear Transport Stream
ID
56
Description
Displays the name of the headend with which the
GoQAM is associated.
Displays the name used for the GoQAM.
Displays the IP address of the Ethernet interface
through which the DNCS manages and controls
the GoQAM.
Allows you to specify one of the following
modulation types for each of the carriers:
ITU J.83 Annex B (6 MHz)

ITU J.83 Annex C DAVIC/DVB

(6 MHz)
Note: The default value is ITU J.83 Annex B (6
MHz).
system. The values are:
Offline – Default

Online – Active

Displays the MAC address of the GoQAM
Displays the IP Subnet mask assigned by the
system administrator.
Displays the network default gateway assigned by
the system administrator.
Description
Identifies the available range of Transport
Stream IDs (TSIDs)
Identifies the Transport Stream ID for input
block 1 at ASI 1
Identifies the Transport Stream ID for input
block 2 at ASI 3
4004834 Rev D