Cisco GoQAM Installation And Operation Manual page 111

Viewing the NP3 Software Revision Level
The NP3 software revision screen displays the revision level for Output 2 processor
in the GoQAM. To display the NP3 software revision screen, follow these steps.
1 Press OPTIONS until the NP3 Software Revision screen appears.
NP3 SW:
1.0.0
Notes:
 In the above example, App is the application code and Boot is the boot code.
 This revision number for the application code (1.0.0) and the boot code
(1.0.0), represented in the above example, contains the major release number,
minor release number, and the point release number.
Important! If an asterisk (*) appears after one of the code version numbers, this
indicates that the code version is a mismatch to the GoQAM software package
version.
2 Press ENTER to return to the default screen.
Viewing the Module Revision Numbers
The Module Revision screen displays the revision numbers for the hardware and
software of the selected RF channel. To display the Module Revision screen,
complete the following steps.
Press OPTIONS until the Module Revision screen appears.
1
Notes:

SW shows the RF board microprocessor firmware revision displayed as
major release and minor release.

If an asterisk (*) appears after one of the code version numbers, this indicates
that the code version is a mismatch to the GoQAM software package version.

Mode is the PWB assembly of configuration. The 0 indicates a
Standard/Domestic Mode (Baseband to RF Output) PWB assembly.
2 Press RF SEL to display Module Revision information for each channel.
3 Press ENTER to return to the default screen.
4004834 Rev D
App Boot
1.0.0
Monitor Setup Options
95