Cisco GoQAM Installation And Operation Manual page 160

Chapter 8 Troubleshooting the GoQAM
Boot Download
Failure Screens
Default Status
Screen
Incorrect
Configuration File
Screens
144
Unable to TFTP Boot Code (Boot Mode=1)

The following message appears if the GoQAM is
unable to download the boot code execution file
from the TFTP server during boot mode 1.
Unable to TFTP Boot Code
Continuing Startup...
The GoQAM then starts the application program.
Unable to TFTP Boot Code (Boot Mode=2)

The following message appears if the GoQAM is
unable to download the boot code execution file
from the TFTP server during boot mode 2.
Unable to TFTP Boot Code
Restarting...
The GoQAM then automatically reboots.
If an RF carrier channel cannot be accessed or is
missing, the following message appears:
CH1
Info Not Available
Invalid Config File (Boot Mode 1)

The following message appears when in boot
mode 1 and the configuration file type is
incorrect for the GoQAM. The first line of the
configuration file contains
GqamBootpFileType=1.0.
Invalid File format
Continuing Startup...
The GoQAM then starts the application program.
Invalid Config File (Boot Mode 2)

The following message appears when in boot
mode 2 and the configuration file type is
incorrect for the GoQAM. The first line of the
configuration file contains
GqamBootpFileType=2.0.
Invalid File format
Restarting...
The GoQAM then automatically reboots.
An incorrect

DNCS
configuration
may also cause
this condition.
Reinstall the

GoQAM
package on the
DNCS if all
GoQAMs have
this error
condition.
Check IP

connectivity.
Contact Cisco

Services.
A possible RF

hardware
problem
occurred.
Contact Cisco

Services.
Correct the

configuration
file.
Contact Cisco

Services.
4004834 Rev D