Cisco GoQAM Installation And Operation Manual page 134

Chapter 6 Operating the IF GoQAM
Viewing the NP3 Software Revision Level
The NP3 software revision screen displays the revision level for Output 2 processor
in the GoQAM. To display the NP3 software revision screen, follow these steps.
1 Press OPTIONS until the NP3 Software Revision screen appears.
NP3 SW:
1.0.0
Notes:
 In the above example, App is the application code and Boot is the boot code.
 This revision number for the application code (1.0.0) and the boot code
(1.0.0), represented in the above example, contains the major release number,
minor release number, and the point release number.
Important! If an asterisk (*) appears after one of the code version numbers, this
indicates that the code version is a mismatch to the GoQAM software package
version.
2 Press ENTER to return to the default screen.
Viewing the HW Rev String GoQAM
The Revision Control screen displays the hardware revision string of the GoQAM.
This string is 31 bytes long and is stored in non-volatile memory. Only eight
characters of the string can be viewed at a time.
Press OPTIONS until the Revision Control screen appears.
1
2 Press the Up or Down Arrow keys to display the next or previous eight
characters of the hardware revision string.
Note: The " ->" indicates that more characters are available.
Press ENTER to return to the default screen.
3
118
App Boot
1.0.0
4004834 Rev D