Chapter 3 Provision The Rf Goqam - Cisco GoQAM Installation And Operation Manual

4004834 Rev D
3 Chapter 3
Provision the RF GoQAM
Introduction
This chapter provides examples and descriptions of the DNCS graphical
user interfaces (GUIs) used for provisioning (configuring) the RF
GoQAM in an Overlay environment. Provisioning the GoQAM prepares
the device so that the DNCS recognizes it and so that it operates
properly.
Important! Your system must be operating SR 2.4/SR 3.4 (or later) to
use a GoQAM on your system. You must also have the Overlay feature
enabled.
Note: See Technical Specifications (on page 149) for the technical
specifications of the RF GoQAM and consult your network wiring
diagram when you provision the GoQAM to ensure a proper allocation
of bandwidth.
For more information about the DNCS and operating the DNCS
software, refer to the Digital Network Control System Online Help for your
system release.
In This Chapter
 Understand the RF GoQAM GUIs ..................................................... 38

Provision GoQAMs on the DNCS ...................................................... 46
37