Cisco GoQAM Installation And Operation Manual page 130

Chapter 6 Operating the IF GoQAM
Displaying Alarm Status
Follow these steps to display the list of active alarms.
Press OPTIONS. The Alarm Status screen appears.
1
Notes:

Each alarm description appears for approximately 1 second before displaying
the next alarm. If no alarms are active, a No Active Alarms message appears.
 See Troubleshooting Alarm Messages for detailed descriptions of alarms.
2 Press ENTER. The default screen appears.
Viewing the Session Count
The Session Count screen displays the count of all active sessions for the selected IF
output. Follow these steps to view the total number of active sessions.
Press OPTIONS until the Session Count screen appears.
1
Note: The session count for the GoQAM will differ from the session count on the
DNCS if the GoQAM does not find needed MPEG programs within MPEG
Program Specific Information (PSI). By design, the GoQAM responds positively
to a session setup request even if the requested MPEG program is not present on
the input transport stream.
Press RF SEL to view the session count for each channel (IF1 or IF2).
2
Press ENTER to return to the default screen.
3
Viewing the Program Count
The Program Count screen displays the encrypted programs currently running on
the selected IF output. Follow these steps to view the program count for an IF
module.
1 Press OPTIONS until the Program Count screen appears.
Press RF SEL to view the program count for each channel (IF1 or IF2).
2
3 Press ENTER to return to the default screen.
114
Alarm at 11:51:03
Input1 loss of signal
IF1 Session Count
10
IF1 Program Count
5
4004834 Rev D