Table of Contents
Advertisement
Configuration
Modem Setup
Use the Modem Setup screen (MENU
configure your modem.
1.
2.
3.
4.
5.
Rev 3.01
Figure 3-48
Note
Modem setup is done through the RS232/RS485 screen
in the Devices menu which can be accessed from the
Main Menu.
If the RS232 port is in use for the remote control, the
networking cannot be configured by the modem. In the
RS232/RS485 Setup menu, set up the RS232 port to
communicate with the external modem first.
Highlight the box beside Baud Rate of the RS232 field and then press # . A list of
baud rates ranging from 300 to 115,200 displays.
Highlight the box beside Parity of the RS232 field and then press # . A drop-down
list displays. You can select from None, Odd, or Even parity.
Highlight the box beside Data Bit of the RS232 field. Press # to toggle between 7
bit and 8 bit formats.
Highlight the box beside Stop Bit of the RS232 field. Press # to toggle between 1
and 2 Stop Bits.
To save your changes, highlight OK and then press # . Select Cancel to exit the
screen without saving the changes.
Network
Modem Setup Screen
67
Network Setup
Modem) to
Document 900.0258
10/05
Advertisement
Table of Contents
