Table of Contents
Advertisement
Configuration
4.
5.
6.
Rev 3.01
Highlight the box beside Transfer Control and then press # to toggle between
On and Off. When On, you can set the transfer speed and remote quality of the
image transferred to a computer running RAS (Remote Administration System)
software.
Highlight the box beside Transfer Speed and then press # . Select the transfer
speed from 1 to 30 ips.
Note
The transfer speed you set is the maximum speed. Depending
on the network environment, this speed may not be achieved.
The transfer speed indicates the image rate transferred to each
RAS. If two remote sites (RAS) are connecting to the DVR, the
number of images transferred via network will be Transfer Speed
x 2.
The Transfer Control option affects the recording performance of
the DVR. The number of remote sites (RAS) connected to the
DVR does not affect the recording speed. The local recording
speed is affected only by Transfer Speed. The local recording
speed is not affected if the DVR is not connected remotely.
If Transfer Control is not used, data transfer speed to a remote
site will be the same as the local recording speed.
Highlight the box beside Remote Quality and then press # . Select the image
quality from Very High, High, Standard, and Low.
62
Document 900.0258
10/05
Advertisement
Table of Contents
