Configuration
Configuring Recording Settings
Your DVR offers a variety of flexible recording modes:
•
•
•
Highlight Record Mode, Time-Lapse Record or Pre-Event Record in the Record
menu and then press # . The following recording setup screen display.
Record Mode Setup Screen
Access the Record Mode Setup screen (MENU
press # . The Record Mode Setup screen displays.
1.
2.
Rev 3.01
Note
Pressing REC on the front of the DVR causes the red LED to light
and indicates the DVR is ready to record. However, this does not
mean the DVR is recording. The DVR records video based on the
parameters such as schedule and events defined during
configuration.
You can set it up to record all the time or to only record events.
It can be set up to continue recording after the hard disk drive is full by recording
over the oldest video.
You can set it up to alert you when the hard disk is full and stop recording.
Figure 3-27
Highlight the box beside Record Resolution and select from High and Standard.
All the other variables being equal, selecting High decreases the recording and
playback speed by half of Standard.
Highlight the box beside End Of Disk and then press # . This toggles between
Overwrite and Stop.
Record Mode Setup Screen
45
Record
Record Mode) and then
Document 900.0258
10/05