Table of Contents
Advertisement
Operation
The front panel controls are described in
Turning on the Power
After you have installed the DVR following the instructions in
ready to record.
The DVR recovers automatically after the unit is initialized if recorded data on the
storage device has been damaged.
Live Monitoring
As soon as the DVR completes its initialization process, it will begin showing live video
on the attached monitor and playing live audio through the attached speaker. The
default mode is to display all cameras at the same time. Pressing any camera button
causes that camera to display full screen. It displays live video and plays live audio until
the user enters another mode.
Press DISPLAY to cycle the DVR through the different display formats.
You can set the DVR to display the event-detected video in full screen on the monitor
during the preset dwell time when there is an Event. The video of the lowest camera
number among cameras associated with the event-detected sensor displays and the
DVR returns to the previous screen format after event monitoring dwell time. While the
event monitoring is activated, the monitoring for all other subsequent events is ignored.
Pressing any individual camera button or DISPLAY during event monitoring releases
the current event monitoring and displays the selected camera or returns to the
previous screen format.
Rev 3.01
Figure 4-1
DVR Front Panel (16-Channel Shown)
Chapter 3,
Configuration.
82
Chapter 2,
Installation, it is
Document 900.0258
10/05
Advertisement
Table of Contents
