Setting Unit For Ntsc Or Pal; Figure 2-1 Dvr Rear Panel (16-Channel Shown); Figure 2-2 Ntsc/Pal Switch - Honeywell HRHD4+ User Manual

Installation

Setting Unit for NTSC or PAL

You can use your DVR with either NTSC or PAL equipment. Before turning on the DVR,
set the switch to NTSC or PAL to match your equipment.
Caution
Rev 3.01
Figure 2-1 DVR Rear Panel (16-Channel Shown)
Figure 2-2 NTSC/PAL Switch
N
Note You cannot mix NTSC and PAL equipment. For example, you
cannot use a PAL camera and an NTSC monitor.
If you set the switch from NTSC (PAL) to PAL (NTSC), please do
the Factory Reset and Clear All Data. If not, it causes the DVR to
perform wrong operations.
P
6 Document 900.0258
10/05