Table of Contents
Advertisement
Operation
Pressing SEQUENCE causes the cameras to display sequentially on the monitor.
When in one of the multi-view formats, pressing this button causes the DVR to cycle
through user-defined screen layouts (page sequence), or the bottom, right screen to
display live cameras sequentially (cameo sequence). Selecting another display mode,
or pressing SEQUENCE again exits the Sequence mode. When in one of the multi-view
formats, pressing the Left or Right Arrow buttons causes the DVR to go to the previous
or the next page. For example, if you press the Right arrow button in 2x2 format, the
DVR changes the page like the one shown below.
For the sequence display on the spot monitor, press SPOT + SEQUENCE.
Press FREEZE to freeze the current image on the screen until you press the button
again.
Active Cameo Mode
You can enter the Active Cameo mode by pressing # in any multi-view format. The
gray-highlight box at the bottom of video indicates the active cameo, and pressing the
Arrow buttons moves the active cameo. Pressing # while in the Active Cameo mode
exits the Active Cameo mode. The active cameo mode will remain in effect for 15
seconds if there is no further action.
In Active Cameo mode, press the camera button of the video you want to show at active
cameo. After setting the camera number at active cameo, the DVR moves the active
cameo to the next cameo. You can change the screen layout using this process.
Active Cameo mode can also be used to select the camera to control Pan, Tilt and
Zoom capabilities.
PIP Mode
You can display a Picture-in-Picture by pressing DISPLAY. You can change the location
of the PIP by pressing the Up and Down Arrow buttons and its size by pressing the Left
and Right Arrow buttons.
Rev 3.01
83
Document 900.0258
10/05
Advertisement
Table of Contents
