Configuration
Motion Detector
Your DVR has a built-in video motion detector. Use the Motion Detector screen to turn
video motion detection On or Off for each camera and to define the area of the image
where you want to detect motion.
Highlight Motion Detector in the Device menu (MENU
and then press # . The Motion Detector screen displays.
Your DVR has built-in video motion detector. Video motion detection can be turned On
or Off for each camera.
To adjust the DVR sensitivity to motion, highlight the box under the Sensitivity heading.
There are five settings from 1 to 5—1 is the least sensitive and 5 is the most sensitive.
You can adjust the minimum number of detection blocks that must be activated to
trigger a motion alarm. Highlight a box under the Min Size heading and adjust the
number. The smaller the number, fewer detection blocks must be activated and
therefore the sensitivity is increased.
Turning the View setting On allows you to observe how the DVR is reacting to motion.
When in the motion viewing mode, the detection zone of video displays in green. Any
detected motion within the zone displays in red.
You can define the area of the image where you want to detect motion; for example, a
doorway. Highlight the icon under the Zone heading, and then press # . The Motion
Detection Zone screen displays.
Rev 3.01
Figure 3-20
Motion Detector Screen
39
Device
Motion Detector)
Document 900.0258
10/05