Show Interfaces Configured - Dell S6100 Configuration Manual

Related Commands
•
•
•

show interfaces configured

Display any interface with a non-default configuration.
Syntax show interfaces configured
Command Modes
•
•
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.1)
9.10(0.0)
9.8(2.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.2(1.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
7.6.1.0
7.5.1.0
6.4.1.0
Example
Dell# show interfaces configured
TenGigabitEthernet 1/1/1/1 is up, line protocol is up
Hardware is Force10Eth, address is 00:01:e8:05:f7:fc
Current address is 00:01:e8:05:f7:fc
Interface index is 474791997
Internet address is 1.1.1.1/24
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed 1000 Mbit, Mode full duplex, Master
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interfaces" counters 00:12:42
Queueing strategy: fifo
706 Interfaces
show interfaces configured
show ip interface – display Layer 3 information about the interfaces.
show range – display all interfaces configured using the interface range command.
EXEC
EXEC Privilege
Description
Introduced on the S6010-ON and S4048T-ON.
Introduced on the S6100–ON.
Introduced on the S3100 series.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series.
Introduced on the S-Series.
Introduced on the C-Series.
Changed the organization of the display output.
– display any interface with a non-default configuration.